DCS RDT-366SS Guía de instalación descargar pdf (Pagina 7)

UNPACKING AND HANDLING

CAUTION:

Proper equipment and adequate manpower must be used in moving the range

to avoid damage to the unit or the floor. The unit is heavy and rests on

adjustable steel legs.

WARNING:

DO NOT lift range by the oven door handles!!

WARNING:

DO NOT remove the grill or

griddle assemblies!!

It may be necessary to remove the oven doors and

knobs to pass through some doorways. With the

doors and knobs removed, a 29 1/16”(RGS-36/48) or

29 3/8”(RGS-305) wide opening is required. Without

removing the door, a 31 1/2”(RGS-36/48) or 30”(RGS-

305) wide opening is required. Remove the outer

carton and packing material from the shipping base.

Remove the kick panel by removing two screws at

the top and pulling forward. The range is held to the

skid by two bolts in the front behind the kick panel,

(fig. 1 pg. 5) and two L-brackets located on the

bottom flange of the range back (fig . 2). After

removing the bolts and brackets, the range must be

lifted and removed from the skid.

Due to the weight, a dolly with soft wheels should

be used to move this unit. The weight must be

supported, uniformly across the bottom (fig. 3). To

remove the door, open the door and hold it all the

way open. Close the hinge latches (fig. 4 pg. 7) and

release the door. The door can then be removed by

gently lifting and pulling the door, with the hinges

up and out of the frame.

Electric and gas connections should be made (see

page 13 & 14) before the range is slid into the

cabinet opening. If installing a full backguard with

the range it should also be installed before the

range is placed in its final position (refer to page 5)

for proper performance, the professional range

should be level. To achieve a flush fit of the range to adjoining countertops,it will be necessary to have

level cabinets (front to back, and left to right across opening of the range).

Left Rear Shipping

Screws

Fig. 2

22"

Leveling Legs

Range Must

be Uniformly

Supported

on Braces

Fig. 3

Left Rear

Shipping Screws

Range Must

Be Uniformly

Supported on

Braces

Leveling Legs

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Comentarios a estos manuales

Sin comentarios

DCS RDT-366SS Guía de instalación Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Cocinas DCS RDT-366SS