DCS RDT-366SS Guía de instalación descargar pdf (Pagina 15)

ELECTRICAL / GAS CONNECTIONS

GAS REQUIREMENTS

Verify the type of gas supplied to the location. The

range are shipped from the factory set up and

adjusted for natural gas or LP (propane),depending on

specific model ordered. The unit CANNOT be

converted.

NATURAL GAS

 Connection: 1/2” N.P.T. Minimum 5/8” dia. flex

line.

 Pressure: 6”to 14”W.C.

LP GAS

 Connection: 1/2” N.P.T. Minimum 5/8 dia. flex

line.

 Pressure: 11”to 14”W.C.

A regulator is required at the LP source to provide a

maximum of 14”W.C. to the range regulator.

HOOK-UP

A manual valve must be installed external to the appliance,in an accessible location from the front for

the purpose of shutting off the gas supply. The supply line must not protrude beyond the back of the

unit. Make sure the gas supply is turned off at the wall valve before connecting the appliance.

The gas supply connections should be made by a qualified technician and in accordance with local

codes or ordinances. In the absence of a local code,the installation must conform to the National Fuel

Gas Code ANSI 223.-1988, latest edition.

NOTE: The flex line for the gas supply must be metal and be approved by an approved certifying

agency (AGA,CGA,CSA,or UL). Never use a hose made of rubber or other synthetic material,as the heat

may cause the hose to melt and develop leaks.

CAUTION:

The appliance must be isolated from the building’s gas supply piping system

by closing its individual manual shut-off valve during any pressure testing of

the gas supply piping system at test pressures equal to or less than 1/2 psig

(3.5kPa.).

The appliance and its individual shut-off valve must be disconnected from

the gas supply piping system during any pressure testing of the system at the

test pressures in excess of 1/2 psig (3.5kPa.). When checking the manifold gas

pressure, the inlet pressure to the regulator should be at least 7.0” W.C. for

natural gas or 12.0” for LP.

Fig. 14 All RGS Models

Ele

2" Maximum

Protrusion from Wall

for Gas Supply

Gas Supply

Flex Line to Range

Manual Shut-Off

Valve must be

Easily Accessible

Gas Supply

Flex Line To Range

Manual Shut-Off

Valve Must Be

Easily Accessible

2” Maximum

Protrusion From

Wall For Gas

Supply

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Comentarios a estos manuales

Sin comentarios

DCS RDT-366SS Guía de instalación Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Cocinas DCS RDT-366SS