DCS HD30 Manual de usuario descargar pdf (Pagina 17)

INSTALLATION INSTRUCTIONS

Prepare the downdraft unit for the intended blower

Internal blower



Remove the 10” (254 mm) blower connection plate from the front of the downdraft

unit Fig.1.



Attach the over counter mounting brackets in place with the two ⁄” (5mm) screws

provided Fig.2.



Screw the support leg mounting brackets to the side of the downdraft unit using two

⁄” (8mm) screws each, do not fully tighten the screws. The brackets are different

for the right and the left side. Attach them with mounting clip (A) pointing up.

Remote blower



The downdraft unit comes ready for installation with the 10” (254 mm) remote blower

connection plate installed on the front of downdraft unit and the cover plate installed

onto the back.



To connect the remote blower to the back of the downdraft unit swap the plates over

(see Fig. 3 and 4)



Attach the over counter mounting brackets in place with the two ⁄” (5mm) screws

provided Fig.2.



Screw the support leg mounting brackets to the side of the downdraft unit using two

⁄” (8mm) screws each, do not fully tighten the screws. The brackets are different

for the right and the left side. Attach them with mounting clip (A) pointing up.

FRONT

Fig.1

Fig.3

Fig.4

FRONT

2 x

4 x

Fig.2

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Sin comentarios

DCS HD30 Manual de usuario Pagina 17