Dcs RDT-305 Manual de usuario descargar pdf (Pagina 19)

BACKGUARD INSTALLATION

he backguard is located as shown in Fig. 14. Secure

the backguard to the wall behind the range. Specific

instructions for installation of the full backguard or low

backguard can be found packaged with the backguard.

See also page 8, “Planning The Installation” section. A

ackguard must be installed when there is less than a

12” clearance between combustibles and the back of

the range (above the cooking surface). See fig. 13.

DCS backguards are sold separately.

ELECTRICAL CONNECTIONS – RDT-48 MODELS

Always disconnect electric supply cord from the wall outlet or service

disconnect before servicing this appliance. Observe all governing codes

and ordinances when grounding, in absence of which, observe National

Electrical Code ANSI / NFPA No. 70. The electrical supply must be a

120/240 volt, 3 wire (plus ground) 60 Hz single phase, 50 AMP circuit. The

power receptacle must be a NEMA 14-50 device to accept the four prong

plug supplied with the unit (Fig. 15). The receptacle should be located

within the area shown in fig. 10, page 14.

ELECTRICAL CONNECTIONS – RDT-305 & RDT-36 MODEL

The electrical supply must be a 120/240 volt, 3 wire (plus ground), 60 Hz,

30 AMP circuit. The power receptacle must be a NEMA 14-50 device to

accept the four prong plug supplied with the unit. The receptacle should be located within the area shown in

fig. 11, page 15.

RECOMMENDED GROUNDING METHOD

This appliance is factory equipped with a power supply cord with a four-prong grounding plug. It must be

plugged into a mating grounding, type receptacle, connected to a correctly polarized 120/240 volt circuit. If the

circuit does not have a grounding type receptacle, it is the responsibility and obligation of the installer to have

the existing receptacle changed to a properly grounded and polarized receptacle in accordance with all

applicable local codes and ordinances by a qualified electrician. In the absence of local codes and ordinances,

the receptacle replacement shall be in accordance with the National Electrical Code.

Note:

The fourth prong (round grounding pin) should not, under any circumstances, be cut or removed.

WARNING!

The range is equipped for use with an electrical supply which uses a separate

rounding conductor (4 wire system). If this range must be connected to an

electrical system which utilizes a single conductor for ground and neutral (3

wire system), the grounding jumper at the terminal block must be

connected. The grounding jumper is located behind the front kickpanel.

To connect grounding jumper.

■ Disconnect restaining clip holding jumper.

■ Connect green jumper to open terminal on neutral (white) portion of the

terminal block (fig. 16).

28-1/8"

10-1/8"

1-5/16"

Wall Mount

Full Backguard

(Model #’s BGS-3030,

BGS-3036, BGS-3048)

Wall Mount

Low Backguard

(Model #’s BGS-1230,

BGS-1236, BGS-1248)

Electrical Supply

NEMA 14-50

Receptacle

x Line to Range

ily Accessible

Fig. 15

Fig. 14

ELECTRICAL CONNECTIONS

Connect Here

Red

White

Black

Terminal Block

Green

Fig. 16

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Comentarios a estos manuales

Sin comentarios

Dcs RDT-305 Manual de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Radio Dcs RDT-305