Dcs RDT-305 Manual de usuario descargar pdf (Pagina 15)

INSTALLING ANTI-TIP DEVICE

All ranges must have an anti-tip device correctly

installed as per the following instructions. If you pull

the range out from the wall for any reason, make sure

hat the device is properly engaged when you push

the range back against the wall. If it is not, there is a

ossible risk of the range tipping over and causing

injury if you or a child stand, sit or lean on an open

oven door.

INCLUDED PARTS:

(4) #10 x 2” wood screws,

(1) Anti-tip bracket, and (1) Installation Instructions.

INSTALLING THE KIT:

Instructions are provided for wood and cement

floors. Any other type of construction may require

special installation techniques as deemed necessary

to provide adequate fastening of the Anti-tip bracket

to the floor and wall. The use of this bracket does

not preclude tipping of the range when not properly

installed.

WOOD CONSTRUCTION:

Place the bracket against the back wall, into the right

rear corner where the range is to be located. Leave a

gap between the wall (or side of range) and the bracket (see fig.

8). Drill (2) 1/8” diameter pilot holes in the center of the small

holes. A nail or awl may be used if a drill is not available. Fasten

the bracket securely to the floor and wall.

CONCRETE OR CEMENT CONSTRUCTION:

Hardware Required:

(2) sleeve anchors, lag bolts, and washers (not provided).

Locate the bracket as described above. Drill the recommended

size holes for the hardware. Install the sleeve anchors into the

holes and then install the lag bolts through the bracket. The

bolts must be properly tightened as recommended for the

hardware. Fasten the bracket securely to the floor and wall.

ONCE INSTALLED:

Complete the range installation per the instructions provided

with the product. Check for proper installation of the range and

Anti-tip device by grasping the back of the unit and carefully

attempt to tilt the range forward.

WARNING

ALL RANGES CAN TIP

INJURY COULD RESULT

INSTALL ANTI-TIP

BRACKET PACKED

INSIDE OVEN

SEE INSTRUCTIONS

Fig. 9

Fig. 8

(2) Large Holes for Concrete

Installations

(2) Small Holes for Wood

Installations

(2) Wood Screws into Back

Wall (ALL Installations)

BACK

WALL

RIGHT SIDE OF

WALL OR RANGE

Model

Series

RDT-48 RDT-36 RDT-305

1/2” 5/8” 1/4”

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Comentarios a estos manuales

Sin comentarios

Dcs RDT-305 Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Radio Dcs RDT-305