DCS WDUI models Guía de usuario descargar pdf (Pagina 11)

INSTALLATION INSTRUCTIONS

CUSTOM PANEL INSTALLATION OF THE INTEGRATED WARMING DRAWER WDUI/

WDVI

STEP 1

Remove drawer as per instructions (see section ‘Care and maintenance’).

STEP 2

Check the dimensions of the front face (see Fig. 8).

STEP 3

Cut the custom panel to the desired dimensions, knowing that the panel must cover the paper front template

plus 1/8” on all four sides for a good presentation. The thickness of the custom panel must be greater than

9/16” to allow for clearance for the tips of the screws holding the drawer when the custom panel is mounted.

STEP 4

Center the provided paper front template on the back of the custom panel to drill or cut the clearance areas for

the hardware holding the drawer. (Note: the drill sizes and callouts are on the template.)

STEP 5

Fasten the custom panel to the front face with the supplied screws as shown in Fig. 8.

Fig. 8

25-3/4”

Front face

( WDUI/WDVI

only)

Screws to hold

custom panel to

warming drawer

8-5/16”

10-1/2”

29-11/16”

Paper front

template

ø 1/4” clearance

5/16” deep

ø 1/2” clearance

1/2” deep

11/16” x 2-1/8” clearance

1/8“deep

Custom panel

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Sin comentarios

DCS WDUI models Guía de usuario Pagina 11